Assume AVIXA CTS-I Dumps PDF Are going to be The Best Score
AVIXA Communications CTS-I Exam and Certification Test Engine
AVIXA CTS-I - Installation Exam Syllabus Topics:
| Topic | Weight |
|---|---|
| Duty A: Conducting Pre-Installation Activities | 20% |
| Task 1: Review Audiovisual Project Documentation | 4% |
| Task 2: Conduct Technical Site Survey | 4% |
| Task 3: Prepare for Audiovisual Installation | 4% |
| Task 4: Evaluate Overall Facility Readiness | 4% |
| Task 5: Conduct On-Site Preparations for Installation | 4% |
| Duty B: Conducting Site Rough-In/First-Fix | 10% |
| Task 1: Deinstallation of Existing Equipment and cabling | 2% |
| Task 2: Mount Substructure | 4% |
| Task 3: Pull Cable | 4% |
| Duty C: Installing Audiovisual Systems | 38% |
| Task 1: Assemble AV Rack | 4% |
| Task 2: Wire the AV Equipment Rack | 5% |
| Task 3: Distribute AV Equipment | 4% |
| Task 4: Mount AV Equipment | 4% |
| Task 5: Terminate Cables | 5% |
| Task 6: Configure Network Properties of Equipment | 4% |
| Task 7: Load Configuration and Control Programs | 4% |
| Task 8: Test the AV System | 4% |
| Task 9: Calibrate the AV System | 4% |
| Duty D: Perform Systems Close Out | 11% |
| Task 1: Demonstrate to Client or Client's Representative that System Performs to Specifications | 4% |
| Task 2:Provide Training on System Operation | 4% |
| Task 3:Obtain Project Completion Sign Off from Client or Client's Representative | 3% |
NEW QUESTION # 141
Loudspeakers intended for direct coupled wiring have _____.
- A. transformers with taps
- B. internal amplifiers
- C. low impedance
- D. high impedance
Answer: C
NEW QUESTION # 142
When preparing to install a ceiling mount, what should you determine before you can determine the projector position?
- A. The center of the projector
- B. The center of the projector's mount
- C. The center of the adjustable ceiling support structure
- D. The location of the projection surface
Answer: D
NEW QUESTION # 143
What are best practices when evaluating facility conditions of a space that is ready for installation?
Select all that apply.
Response:
- A. Make sure the site is clean and dust-free
- B. Take pictures and document all existing conditions
- C. Note areas that may impact logistics
- D. Note if you will need an extension ladder
Answer: A,B,C,D
NEW QUESTION # 144
Which device provides a direct physical connection between multiple nodes?
- A. Switch
- B. Gateway
- C. Bridge
- D. Router
Answer: A
NEW QUESTION # 145
Which of the following choices lists the correct pinouts for the T-568A end of a crossover network cable (pin 1-8):
Response:
- A. WOr, Or, WGr, B, WB, Gr, WBr, B
- B. Gr, WGr, WOr, B, WB, Or, WBr, Br
- C. WGr, Gr, WOr, B, WB, Or, WBr, Br
- D. Br, WBr, Or, WB, B, WOr, GR, WGr
Answer: C
NEW QUESTION # 146
Compressors, limiters, and expanders are all _____.
- A. filters
- B. gates
- C. distortion processors
- D. dynamic processors
Answer: D
NEW QUESTION # 147
Under normal circumstances, a ground wire carries _____.
- A. no charge
- B. a line level signal
- C. current to the main distribution panel
- D. a dangerously high voltage
Answer: A
NEW QUESTION # 148
Which of the following are parts of an IP address for a networked device? (Choose all that apply.)
- A. Bit rate
- B. Network identifier
- C. Subnet mask
- D. Host identifier
Answer: B,C,D
NEW QUESTION # 149
What is the total impedance in a loudspeaker circuit wired in parallel with the following specifications: Ten, 4 watt loudspeakers, one individual loudspeaker has a measured impedance of 1380 ohms using a 1 kHz tone.
- A. 138 ohms
- B. 125 ohms
- C. 70.7 ohms
- D. 8 ohms
Answer: A
NEW QUESTION # 150
Which of the following should you do with damaged electrical cable?
- A. fix it
- B. refurbish it
- C. dispose of it
- D. use it
Answer: C
NEW QUESTION # 151
Crimp connections can be properly performed with which of the following tools:
- A. Crimp tool
- B. Soldering Iron
- C. Pliers
- D. All of the above
Answer: A
NEW QUESTION # 152
Why is it better to test control systems in the workshop? (Choose all that apply.)
- A. It may provide better access to help from internal teams.
- B. It allows time for longer breaks.
- C. It allows more time to fix problems.
- D. It prevents customers from asking questions.
Answer: A,C
NEW QUESTION # 153
Transmission is defined as sound energy that is _____.
- A. reflected through a partition
- B. not reflected or absorbed
- C. remaining in the space
- D. absorbed and reflected
Answer: B
NEW QUESTION # 154
In a projected image, adding colors makes the image _____.
- A. brighter
- B. sharper
- C. dimmer
- D. Darker
Answer: A
NEW QUESTION # 155
What is a benefit of using the verification standard for system closeout?
Select all that apply.
Response:
- A. It reduces project risk through early identification of problems, thereby reducing the likelihood of remedial work.
- B. It aligns outcome and performance expectations at an early stage in the project.
- C. It provides a verifiable outcome.
- D. It creates a common language between all parties.
Answer: A,B,C,D
NEW QUESTION # 156
What type of rack would you use for a room with limited space for servicing equipment?
- A. Wall-mounted
- B. Slide out
- C. Fixed stand-alone
- D. Portable
Answer: B
NEW QUESTION # 157
What are the primary colors of light?
- A. red, blue, and green
- B. red, blue, and black
- C. red, blue, and yellow
- D. red, blue, and white
Answer: A
NEW QUESTION # 158
A 1080p HDTV signal with a frame rate of 30Hz will reproduce images at:
- A. 30 frames per second
- B. 30 frames per minute
- C. 30 lines interlaced
- D. 30 lines per scan
Answer: A
NEW QUESTION # 159
......
Use CTS-I Exam Dumps (2026 PDF Dumps) To Have Reliable CTS-I Test Engine: https://freetorrent.actual4test.com/CTS-I_examcollection.html